; === IMPORTANT ===
; Put the name of your ethernet adapter in here.
; Start the simulator and type "show eth" to get a list of device names.
; Then come back here and replace ADAPTER_NAME with e.g. "eth2"
; Even better: Use the \Device\[...] path.

; === UPDATE THIS ===
; att xs ADAPTER_NAME

; === THEN REMOVE THE NEXT TWO LINES ===
echo Whoops! You need to go in and configure your Ethernet interface in infoserver150vxt.ini!
exit


; ==============================================================

; Halt to console (optional)
;
set cpu conhalt

; Enable idle detection
;
set cpu idle

; Attach the NVRAM so that the boot flags can be saved
;
attach nvr vax412.nvr

; Setup SCSI devices. Disable any units that are not required or the
; installation will take a long time to complete as it waits for
; the units to be ready.
;
set rz0 disa
set rz1 rz23  ; System disk
set rz2 cdrom
set rz3 disa
set rz4 disa
set rz5 disa
; SCSI ID 6 is the initiator so is always disabled
set rz7 disa

; Disable all SCSI units on the second controller
;
set rzb0 disa
set rzb1 disa
set rzb2 disa
set rzb3 disa
set rzb4 disa
set rzb5 disa
; SCSI ID 6 is the initiator so is always disabled
set rzb7 disa

; Create a new disk image for the system disk
;
attach rz1 infoserver.rz24

; Start the simulator
;
echo
echo Type boot cpu to proceed.
echo

; Comment these lines if you don't want auto boot
expect '>>>' send 'SET BFLG D0000000\r'; continue
expect '>>>' send 'BOOT DKA100\r'; continue
expect 'Enter Password:' send 'ESS\r'; continue